|
|
|
|
With the Villa 9200, the standard for environmentally friendly toilets has been set higher than ever.
In terms of design, stability, comfort and use, it is the equal of a modern WC in every way.
The built-in, 2-speed fan expels odours and condensation from the toilet and bathroom quietly and effectively. The venting duct can be run straight through an outer wall.
The Villa 9200 can be installed in both warm and cold locations, and will work perfectly well irrespective of the room temperature. It can be placed according to your needs and fastened to the wall or floor.
The Villa 9200 is supplied complete for simple installation, with a venting pipe (Ø75 mm, 40 cm/15.75") to go through a wall and a urine waste hose (Ø32 mm, 2 m/6.5 feet).
Connect the Villa 9200 to a Separett Ejektortank if you want to use the urine as an organic plant nutrient.
|
|
 |
|
|
|
- Description
- Technical data
- Accessories
- Installation
- Download
 |
|
|
|
 |
|
When you sit down the unique pressure seat opens a view screen that otherwise covers the solid waste container. At the same time, the container is rotated so that the contents are evenly distributed.
|
|
Put the lid over the container and use the sliding surfaces to remove the container from the toilet. The toilet is supplied with three containers and ten solid waste bags. Place a bag in the container to simplify cleaning. Additional bags and containers can be purchased if required.
|
|
The 2-speed fan runs continually. Normally at low speed. Speed
2 is used after several consecutive toilet visits or in order to quickly expel excess amounts of condensation, such as after a shower.
The Villa 9200 can be installed without any restrictions as to length or the number of 90° connector pipes, for example, up into a cold loft or through a suitable side of the building. |
|
|
|
|
|
 |
|
 |
|
|
|
For the urine to end up in the front of the toilet, an extension part for the urine basin is included, which is easily snapped on and off if needed |
|
Separett Child seat with the separating function is included with the Separett Villa. The child seat gives a firm hold against the toilet seat and is easy to clean. |
|
Fits all models from 1998. Separett Compostable waste bag is designed to endure the conditions inside the toilet and during the storage period. Then it will slowly disintegrate in the ground or in a composter. |
| Material |
Impact-resistant high-gloss
polypropylene, recyclable |
| Inner container |
23 litres Polypropylene |
| Voltage/Wattage |
110-120V/14.6/18.9W |
| Power consumption |
0.350/0.453 kWh/24 hrs |
| Electrical connection |
Cord 1.22 m, earthed plug |
| Noise level fan |
41/31 dB(A) |
- Child seat
- Vent pipe (Ø75 mm, 40 cm/15.75")
- Vent grid
- Indoor flashing for vent pipe
- Connector pipe 90°
- 2 adapters for vent pipe
- 2 adapters for urine pipe
- Vent cowl
- 2 insect nets for vent pipe
- 3 solid waste containers and 2 lids
- 10 compostable waste bags
- White hose for urine waste (Ø32 mm, 2 m/6.5 feet)
- Silicone sealant compound
- Mounting screws
|
|
|
10/roll. Fits the Villa 9000-series
 Read more |
| |
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
There are no temperature range restrictions for rooms where the Villa is to be installed. The toilet will function in both warm and cold locations. It must be possible to route the urine away and to mount a venting pipe. Access to 110V is necessary.
 |
The venting pipe can be routed though a wall or the roof. The Villa 9200 can be installed without any restrictions as to length or the number of 90° connector pipes, for example, up into a cold loft or through a suitable side of the building.
If there is already a venting pipe from a pre-existing toilet, the new venting pipe can be connected to this.
All Separett Villa models are fitted with condensation collectors and the venting pipe does not need insulation.
|
 |
The urine drainage pipe can be led to the greywater system (e.g. sink or shower), a soakaway or a tank, e.g. the Separett Ejektortank.
Details concerning the most suitable and approved alternative can be obtained from your local Environmental Protection, Public Health and Building departments.
|
|
|
| |
 |
 |
 |
|
Oakville Stamping & Bending, 2200 Speers Rd, Oakville, Ontario, Canada L6L 2X8. E-mail: info@separett.ca
Phone: (905) 827-0320, Fax: (905) 827-6375, www.osb.ca |
|
|
|
